Sewn binding joins folded sections with thread through their spines. The result is sturdy, and the method suits pages you plan to handle often. The steps below cover folding, marking holes, stitching and attaching the covers.
What you need
- Paper folded into sections, cut and ready before you start
- Covers, cut and ready
- A bookbinding or tapestry needle with an eye large enough for your thread
- Strong thread, such as waxed linen or embroidery floss
- An awl
- A bone folder, a ruler, a pencil and a cutting mat
- Clips, or a small weight, to hold the sections together
Step 1: Fold the sections
Fold each sheet in half, then nest a few sheets together to form a section. Crease every fold with a bone folder. Keep the sections the same size, so the spines line up when you stack them.
Step 2: Mark the holes
Open one section and mark the hole positions along the fold. Three to five evenly spaced holes is a common choice for a small album. Keep the first and last holes a little in from the top and bottom edges, so the paper does not tear there.
Use a ruler to keep the spacing even. Make a paper template with the marks, and use it for every section.
Step 3: Punch the holes
Clip each section together and punch through the fold at every mark with the awl. Punch every section against the template, so the holes line up across the whole book.
Step 4: Sew the sections
Pamphlet stitch is a common path for a simple sewn book. The exact path depends on the stitch you choose, so decide before you start. In general:
- Start in the middle section. Thread the needle, leave a short tail inside the book, and pass the needle through the middle hole.
- Work the thread through the holes in turn, moving toward one end of the spine. Go around the spine between holes as the stitch requires.
- Sew back to the middle, then continue toward the other end.
- Tie off at the middle, inside the section, with a secure knot.
Keep the thread snug rather than tight, so the pages sit flat and don’t bunch.
Step 5: Attach the covers
Treat each cover as the outside section. Punch the cover holes against the same template, and stitch the covers in with the sections. This way the covers and the pages are bound in one pass.
Step 6: Tie off and check
Tie off the thread inside the spine, and trim the tails short. Close the book gently and check that the sections open flat. If a section sticks, look at its hole positions first.
Tips
- Practise on scrap paper with two sections before you use the good paper.
- Use a needle that fits the holes without stretching them. A thick needle can tear fine paper.
- Keep the thread tension even as you sew.
- If the paper is thick, use fewer sheets in each section rather than forcing the needle.
Common problems
- Pages tear at the holes. Move the holes further from the edges, or use a smaller awl.
- Stitches are loose. Pull each stitch evenly as you go, and finish with a secure knot.
- The spine bulges. The book has too many sheets or the paper is too thick. Use fewer sheets per section.
For a small book that uses the same kind of binding, see the mini album tutorial. For a decorative spine with exposed stitching, see Japanese stab binding. For quicker options, such as a twine pamphlet or a stapled booklet, see simple DIY and vintage journal ideas.