To DIY a scrapbook cover, cut two stiff boards a little larger than your pages, cover them with patterned paper or fabric, and attach them with a spine that lets the book open. Decorate the outside once the cover is built.
What you need
- Stiff board for the covers. Chipboard or greyboard works well. A thin cereal box works for light use, but it bends more easily.
- Patterned paper, cardstock or fabric for the covering
- A spine material, such as a strip of cardstock or cloth tape
- An adhesive that suits your covering, such as PVA glue for paper or a fabric-safe glue for cloth
- A metal ruler, a craft knife, a cutting mat and a bone folder
- Optional: photo corners, eyelets or ribbon
Step 1: Measure your pages
Measure one page’s height and width. The covers should be a little larger than the pages, so the pages don’t stick out when the book closes. The spine sits between the two covers, so measure its width too.
Step 2: Cut the boards
Cut two boards to the same size. Use a metal ruler and a craft knife, and cut straight edges. Check that the two boards match before you go on.
Step 3: Cover the boards
Cut the covering paper or fabric with a margin on every side, large enough to wrap around the edges. Spread a thin layer of adhesive on the board, lay the covering down, and smooth it from the middle outward. Fold the edges over the board and glue them down. Trim the corners at an angle, so the wrapped corners lie flat.
Step 4: Attach the spine
The spine lets the cover open. Leave a gap between the two boards, about the width of the spine, and bridge it with a strip of cardstock or cloth tape. Glue one end to each board. Let the spine dry flat, then bend it gently a few times so the cover opens smoothly.
Step 5: Line the inside (optional)
Glue a sheet of paper to the inside of each cover. The lining hides the raw board, the wrapped edges and the spine tape, so the book looks neater inside.
Step 6: Decorate the outside
Decorate the cover after it is built. Use layers, a title, a photo or a label. For wording ideas, see the best title for a scrapbook. Keep decorations away from the spine and the edges, so they don’t crack when the album opens. How to decorate a scrapbook covers embellishments in more detail.
Tips
- Test the opening and closing motion before you decorate. If the cover resists, adjust the spine.
- Use a thin layer of adhesive, so the covering doesn’t wrinkle or bubble.
- For fabric, press it flat first and cut with a little extra margin.
Common problems
- The cover bends in the wrong place. The gap at the spine is too narrow or too wide. Adjust the spine width and test again.
- Bubbles under the paper. There was too much adhesive, or the paper was not smoothed from the middle outward. Lift it, add less adhesive, and smooth it again.
Once the cover is ready, the pages need to be bound to it. For sizing pages and choosing a binding, read how to make a photo album for a scrapbook. For a mechanical option with a removable spine, see the binder-ring album.