Handmade Albums

Japanese Stab Binding for Scrapbook Albums

Japanese stab binding for scrapbook albums: plan the holes, sew the visible spine stitch and tie it off, with tips for keeping a sewn spine neat and even.

On this page
  1. What you need
  2. Plan the holes and stitch pattern
  3. Step 1: Prepare the stack
  4. Step 2: Punch the holes
  5. Step 3: Sew the spine
  6. Step 4: Tie off inside
  7. Step 5: Check the spine and covers
  8. Step 6: Decorate the cover (optional)
  9. Stab binding and sewn binding
  10. Tips
  11. Common problems

Japanese stab binding is a sewn binding in which the thread stays visible on the spine. The stitching is part of the design. The pages and covers are sewn together through a row of holes. This guide covers the materials, how to plan the holes, and the sewing steps.

What you need

  • Pages, folded or flat, depending on your design
  • Covers in chipboard or heavy cardstock, cut to size, with patterned paper if you like
  • An awl for punching the holes
  • A bookbinding or embroidery needle with a large eye
  • Linen or waxed cotton thread, in a colour that stands out against the paper
  • A bone folder, a ruler, a pencil and a cutting mat
  • Binder clips to hold the stack together

Plan the holes and stitch pattern

Decide how many holes you want. Many stab bindings use four or more. Mark the holes at equal spacing along the spine with a ruler, and make a paper template from the marks.

Sketch the stitch path on the template before you start. That way you know where the thread will cross the spine, and you can check the pattern before any holes are punched in the good paper.

Step 1: Prepare the stack

Fold and nest any sections, then place the covers on the outside. Line up the spine edges, and clip the stack together at the top and bottom, so nothing shifts while you punch.

Step 2: Punch the holes

Punch each hole through the whole stack with the awl, using the template. Hold the awl upright and punch straight through. Check that the holes line up on every layer before you go on.

Step 3: Sew the spine

Work the thread through the holes in the order you planned. In many stab bindings, the thread crosses the outside of the spine between holes, so the stitching shows. Keep every crossing the same length and neat.

Start from the inside at the middle hole, and leave a short tail inside the book. Work along the spine following your pattern until you reach the last hole. Then return along the spine to finish the design.

Step 4: Tie off inside

Tie the two ends together inside the book, close to the last hole, with a secure knot. Trim the tails short, so they don’t catch on the pages.

Step 5: Check the spine and covers

Open and close the book. Check that the stitches are even and that the covers close flat. If a stitch pulls the cover out of line, loosen it slightly and check again.

Step 6: Decorate the cover (optional)

Add decorations after the binding is finished. Keep them clear of the spine stitches, so the stitching stays visible and the cover still closes.

Stab binding and sewn binding

Japanese stab binding and sewn binding both use thread through holes, which is why people confuse them. The difference is the intent. In stab binding, the spine stitching is meant to be seen, and the pattern is part of the look. A sewn binding aims for a plainer, sturdier spine. For the plainer method, see the sewn binding steps.

Tips

  • Practise the stitch pattern on scrap paper before you use the good paper.
  • Keep the thread tension even, so the crossings look tidy.
  • Use a needle that fits the holes without stretching them.
  • Pick a thread colour that contrasts with the cover, so the pattern reads clearly.

Common problems

  • The holes don’t line up. Mark every hole against one template, and clip the stack before you punch.
  • The stitches pull unevenly. Keep the tension steady, and sew from the same side of the spine each time.
  • The cover won’t close. The stitching is too tight across the spine. Loosen the crossings.

For a small book with a similar binding, see the mini album tutorial. Stab binding also suits a handmade journal, and simple DIY and vintage journal ideas covers ways to give one an aged look.

The complete guide to handmade albums

Ideas to Make a Scrapbook Album
Read the guide

Keep exploring

Guides from other topics

All topics →