A binder-ring album lets you add or remove pages, so it suits a project that keeps growing, such as a pocket-page album. You build the covers from chipboard and fabric, and a ring binder mechanism holds the pages. This guide follows the build from measuring to attaching the mechanism. The measurements are an example, so adjust them to your own inserts.
What you need
- Chipboard for the covers and spine
- Fabric for the outside, with a little extra on each edge
- Thin cardboard for the lining
- Patterned paper for decoration (optional)
- A ring binder mechanism, with its screws
- Double-sided tape, or a liquid adhesive that dries flat
- An awl, or a punch that can go through chipboard
- A screwdriver, a bone folder, a pencil and a ruler
Measure for your inserts
The covers must be larger than the inserts, or the pages will stick out. As a rule of thumb, add at least 2 inches to the width and 1 inch to the height of your insert size.
For example, 3 by 8 inch inserts need covers of 5 by 9 inches (3 + 2 wide, 8 + 1 tall). The spine is 2 inches wide and 9 inches tall in this example.
Check your binder mechanism
Some ring mechanisms arrive without screws, so check the listing before you order. Overseas sellers can take several weeks to deliver, so order early.
Cut the chipboard
Cut two covers, 5 by 9 inches each, and one spine, 2 by 9 inches. Use your own measurements if your inserts are a different size.
Mark the screw holes
On one cover, measure 1/4 inch in from one long edge and draw a line. Line up the ring mechanism with this line and mark where the screw holes fall. Punch through each mark with the awl, so the screws can pass through.
Set out the pieces
Lay the pieces from left to right: front cover, spine, back cover. Leave a gap of about 1/8 inch between each piece. The gap lets the album fold cleanly.
Cover with fabric
Place the fabric over the chipboard and cut it around the edges, leaving at least 1/2 inch of extra fabric on each side. Mark the screw holes on the fabric with the awl, then enlarge them slightly with scissors so the screws can pass through.
Remove the fabric, add adhesive to the chipboard, and lay the fabric back down. Match the holes. Turn the album over, so the order is still front cover, spine, back cover.
Trim the fabric corners at an angle, then fold the excess over each edge and secure it with tape or adhesive.
Line the inside
Center a sheet of thin cardboard on the inside of the album. Leave a border of about 1/4 inch at each edge. Hold one edge in place with a clip, then spread adhesive under the liner and smooth from one side to the other.
Score both sides of the spine with a bone folder, using the side of the folder rather than the tip, so you don’t tear the liner. Fold the album back and forth a few times so the spine takes its shape.
From the back of the album, punch through the liner so the screw holes show.
Add a patterned layer (optional)
Cut patterned paper to the size of the liner and attach it the same way. A thick print can crack along the spine, so you can leave the spine uncovered. Punch through this layer too, so the holes line up.
Attach the binder mechanism
Place the screws from the back of the album. Set the ring mechanism over them, and secure each one with the matching screw from the front. Tighten them evenly.
Tips
- Test-fit a few pages before you tighten the mechanism. Make sure the rings close without catching.
- Check the hole positions against the mechanism before you punch through the fabric.
- Press lightly when punching chipboard, since it can split under too much pressure.
Once the album works, see how to DIY a scrapbook cover for other cover methods, or how to make a photo album for a scrapbook for page sizing and photo-safe materials.