There is no single best setting that works for every machine and every glitter cardstock. Start with the glitter cardstock or closest cardstock material setting in Cricut Design Space, run a small test cut, and adjust only if the cut is incomplete or the paper tears. Cricut’s help center has instructions for glitter cardstock, which is a good place to check for your machine.
Why glitter cardstock is harder to cut
Glitter cardstock can be thicker or stiffer than plain cardstock, and the glitter layer can shed onto the blade and the mat. Together, these can cause incomplete cuts, torn edges or a sheet that slips during cutting. A test cut catches these problems on a small piece instead of a full project.
Before you cut
- Choose the material setting. If Design Space lists a glitter cardstock setting for your machine, start there. If it does not, start with the closest cardstock setting.
- Use the recommended blade and mat. Follow the blade and mat that Design Space suggests for your material, and check that the blade is clean and sharp.
- Match the mat grip to the paper. If the sheet slides on the mat, use a stronger grip mat. A small amount of removable tape at the corners can also help, though it should be used with care.
- Clean the blade and mat. Glitter collects in the blade housing and on the mat. Brush or wipe away debris before each session.
- Check the orientation. Look up the glitter side’s correct orientation in the paper manufacturer’s instructions or Cricut’s guidance for your material.
Test cut
- Cut a small shape from the same sheet, such as a one-inch square or a small circle. Use a scrap section, not the middle of a project piece.
- Remove the shape from the mat and check the edges. The cut should go all the way through without tearing.
- If the cut is incomplete, change one setting at a time. On some machines, custom settings let you adjust pressure or the number of passes.
- If the paper tears, try less pressure or a stronger grip. If the blade does not cut through, try more pressure or an extra pass.
- Once a setting works, save it as a custom material if your version of Design Space allows it, so you can reuse it.
Test cuts use a little paper, but they save more than they cost when a full project would otherwise fail.
Weeding and cleanup
Glitter can make weeding harder, and small pieces can stick to the mat. Peel slowly, and use a weeding tool or tweezers for fine detail. Brush glitter off the mat between cuts, since a dusty mat grips less reliably. If you plan to add glitter to other sheets, see how to adhere glitter to paper.
Troubleshooting
- Incomplete cuts: check that the blade is clean and seated correctly, then test again with a small change to pressure or passes.
- Torn edges: lower the pressure, check that the paper is not too thin for the setting, and make sure the blade is sharp.
- Sheet slips: use a stronger grip mat, or secure the corners as described above.
- Glitter clinging to the mat: brush the mat, and keep the cutting area clean between projects.
Once your test cut comes out clean, the same setting usually works for the rest of the sheet. If you are using glitter sheets on a layout, how to decorate a scrapbook explains where glitter pieces fit best, and Cricut scrapbook layouts covers cut titles, frames and layered shapes.